Skip to content
Get The Audio You Want Now & Pay Later- Check Out Our Financing Options
Get The Audio You Want Now & Pay Later- Check Out Our Financing Options

The 2.0kw competition series amplifier is a 2,000 watt mono block. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped. It comes with a bass knob and a clipping indicator. For power inputs it will accept 0 awg for power and 0 awg for ground.

Key Features • 1 ohm stable • Variable low pass filter • Variable subsonic filter • Variable bass boost • Wired remote control • Clipping indicator

We recommend for installation • 1 upgraded battery under the hood • 1 extra battery in the rear • Minimum of one 0 awg ran from the front battery to the rear battery • Upgraded aftermarket alternator • Dash mounted voltage meter

Specifications
  Features Voltage 2.0kw
Output Power (RMS) 4 ohm 14.4V 600W x 1
  2 ohm   1,200W x 1
  1 ohm   2,000W x 1
  1 ohm 16V No
  1 ohm 18V No
Input Sensitivity     6V~0.2V
Low Pass Filter Switchable    
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable    
( @ 24dB slope ) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response   Hz 15-270
Signal to Noise Ratio   dB 100
Damping factor     150<
Efficiency @ 4ohm   % Over 90%
THD @ 4ohms     Less than 0.1%
Fuse Rating     200 Amps
Linked Fuse Rating     400 Amps
Indicator Power   Yes
  Protection   Yes
  Clip   Yes
Speaker & Power terminal Mold Type   Yes
  Power Gauge 0Ga
Heatsink Length inch/mm   17.72" / 450mm
Heatsink Width inch/mm   9.38"/238mm
Heatsink Height inch/mm   2.35"/59.6mm

Key Features

• 1 ohm stable

• Variable low pass filter

• Variable subsonic filter

• Variable bass boost

• Wired remote control

• Clipping indicator