Skip to content
Get The Audio You Want Now & Pay Later- Check Out Our Financing Options
Get The Audio You Want Now & Pay Later- Check Out Our Financing Options

The 10.0kw competition series amplifier is a 10,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped for 20,000 watts of power. It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.

Key Features • 1 ohm stable • Variable low pass filter • Variable subsonic filter • Variable bass boost • Wired remote control • Triple 0 awg power and ground inputs

We recommend for installation • 1 upgraded battery under the hood • 3 extra 800ci battery in the rear • Minimum of two 0 awg ran from the front battery to the rear batterys • All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp • 2 upgraded aftermarket alternators • Dash mounted voltage meter

Specifications
  Features Voltage 10.0kw
Output Power (RMS) 4 ohm 14.4V 3,000W x 1
  2 ohm   5,500W x 1
  1 ohm   10,000W x 1
  1 ohm 16V N/A
  1 ohm 18V N/A
Input Sensitivity     6V~0.2V
Low Pass Filter Switchable    
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable    
( @ 24dB slope ) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response   Hz 15-270
Signal to Noise Ratio   dB 100
Damping factor     150<
Efficiency @ 4ohm   % Over 90%
THD @ 4ohms     Less than 0.1%
Fuse Rating     1,000 Amps
Linked Fuse Rating     2,000 Amps
Indicator Power   Yes
  Protection   Yes
  Clip   Yes
Speaker & Power terminal Mold Type   Yes
  Power Gauge 0Ga x 3
Heatsink Length     37
Heatsink Width inch/mm   11.5
Heatsink Height     2.6

Key Features

• 1 ohm stable

• Variable low pass filter

• Variable subsonic filter

• Variable bass boost

• Wired remote control

• Triple 0 awg power and ground inputs