Jensen Dub Edition DUBa1100D 1100 Watt MonoBlock Car Audio Class D Amplifier/Amp



Only 0 left in stock

SKU: Vox-DUBa11000D. Categories: , .


Bragging Rights
This DUBa11000D Jensen DUB Edition amplifier Class D amp uses less power, takes up less space, and generates less heat than traditional amp designs for improved efficiency and reduces idle current. The DUBa11000D is driven by a MOSFET power supply with high current international rectifier output transistors offering impressive power and extensive controls for fine-tuning your sound. Its sleek design was influenced by DUB adding a touch of edge and sexiness.

With a rated RMS of 425 Watts x 1-Channels into 4-Ohms and additional power output of 675 Watts RMS x 41-Channel into 2-Ohms and 900 Watts RMS x 1-Channel 1-Ohm is sure to satisfy your need for power. The DUBa11000D optimized class AB design minimizes distortion and reduces idle current. With this much power you will be able to power DUB Edition speakers or our high quality DUB Edition subwoofer at the bridged impedance.

This amplifier features superior audiophile sound quality and will provide constant reliable power so that you can keep playing louder and longer. Its offset and Thermal Overload Protection technology will keep the amp from overheating or shutting down. This will not only protect you amplifier and subs but also your vehicle from any unwanted blowout or power spark.

CEA Specifications:
Power Output: 475 Watts RMS x 1-Channel Into 4-Ohm @ 1% THD+N
Signal to Noise Ratio: 100dBA Below Reference (Reference: 1 Watt, 4-Ohm)

Additional Power Output:
765 Watts RMS x 1-Channel Into 2-Ohm @ 1% THD+N
1000 Watts RMS x 1-Channel 1-Ohm @ 1% THD+N
Frequency Response: 10 Hz-300 Hz, -3dB (Reference: 1 Watt)

  • MOSFET Power Supply

  • High Current International Rectifier Output Transistors
  • Optimized Class D Design for Improved Efficiency and Reduced Idle Current
  • Designed to Drive 4-Ohm and 2-Ohm & 1-Ohm Loads
  • Continuously Variable Low-Pass Filter: 40 – 300Hz (12dB / Octave)
  • Continuously Variable Subsonic Filter: 10 – 40Hz (12dB / Octave)
  • Continuously Variable Bass EQ: 0 ~ 12dB at 45Hz
  • Phase Switch 0* ~ 180*
  • Pass-Thru RCA’s
  • Short Circuit, DC – Offset and Thermal Overload Protection
  • Diagnostic LED’s: Red – Power / Amber – Fault

RMS Output Power @ 2% THD+N, 1kHz, 14.4VDC  Mono 1×5000 Watts, 4-Ohm
Mono 1×800 Watts, 2-Ohm
Mono 1×1100 Watts, 1-OhmImpedance  1 – 4-OhmFrequency Response  10Hz – 300Hz, -3dBTHD+N @ 1 kHz, 1 Watt  0.02%Signal to Noise Ratio  >100dB (@Rated Power)Input Sensitivity  400mV-5VWeight (Kg/lb)  6.8 lbsInput Impedance  20k Ohms NominalFuse/Type  3 x 35 Amp ATO FuseSize  L 13.28″ x H 2.0″ x W 8.1″

Additional information

Weight 10 lbs