DC Audio DC7.5K-A3 9200W RMS Mono Class D Car Amplifier/Amp+Bass Knob


$1,899.95

In stock

SKU: DC-A3-7.5Kw Categories: ,

The 7.5kw competition series amplifier is a 7,500 watt mono block. It is capable of running up to 18 volts
for up to 9,200 watts. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped.
It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power
and dual 0 awg for ground.

Key Features

1 ohm stable
Variable low pass filter
Variable subsonic filter
Variable bass boost
Wired remote control
Dual 0 awg power and ground inputs (both must be used)

We recommend for installation
1 upgraded battery under the hood
3 extra 800ci battery in the rear
Minimum of two 0 awg ran from the front battery to the rear batterys
Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp
2 upgraded aftermarket alternators
Dash mounted voltage meter

Specifications
Features Voltage 7.5kw
Output Power (RMS) 4 ohm 14.4V 2,000W x 1
2 ohm 4,400W x 1
1 ohm 7,500W x 1
1 ohm 16V 8,600W x 1
1 ohm 18V 9,200W x 1
Input Sensitivity 6V~0.2V
Low Pass Filter Switchable
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable
( @ 24dB slope ) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response Hz 15-270
Signal to Noise Ratio dB 100
Damping factor 150<
Efficiency @ 4ohm % Over 90%
THD @ 4ohms Less than 0.1%
Fuse Rating 750 Amps
Linked Fuse Rating 1500 Amps
Indicator Power Yes
Protection Yes
Clip No
Speaker & Power terminal Mold Type Yes
Power Gauge 0Ga x 2
Heatsink Length inch/mm 32.28″/820mm
Heatsink Width inch/mm 9.38″/66mm
Heatsink Height inch/mm 2.35″/59.6mm

Weight 15 lbs
Dimensions 22 x 10 x 3 in