DC Audio DC5.0K-A3 7300W RMS Mono Class D Car Amplifier/Amp+Bass Knob


$1,479.95

SKU: DC-A3-5.0Kw Categories: ,

The 5.0kw competition series amplifier is a 5,000 watt mono block. It is capable of running up to 18 volts
for up to 7,300 watts. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped.
It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power
and dual 0 awg for ground.

Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Clipping indicator
• Dual 0 awg power and ground inputs (both must be used)

We recommend for installation
• 1 upgraded battery under the hood
• 1 extra 800ci battery in the rear
• Minimum of two 0 awg ran from the front battery to the rear battery
• Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp
• Upgraded aftermarket alternator
• Dash mounted voltage meter

Specifications
Features Voltage 5.0kw
Output Power (RMS) 4 ohm 14.4V 900W x 1
2 ohm 2,300W x 1
1 ohm 5,000W x 1
1 ohm 16V 6,000W x 1
1 ohm 18V 7,300W x 1
Input Sensitivity 6V~0.2V
Low Pass Filter Switchable
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable
( @ 24dB slope ) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response Hz 15-270
Signal to Noise Ratio dB 100
Damping factor 150<
Efficiency @ 4ohm % Over 90%
THD @ 4ohms Less than 0.1%
Fuse Rating 500 Amps
Linked Fuse Rating 1000 Amps
Indicator Power Yes
Protection Yes
Clip Yes
Speaker & Power terminal Mold Type Yes
Power Gauge 0Ga
Heatsink Length inch/mm 25.59″/650mm
Heatsink Width inch/mm 9.38″/66mm
Heatsink Height inch/mm 2.35″/59.6mm

 

Weight 15 lbs
Dimensions 22 x 10 x 3 in